How to ride a manual quad

Accelerate slowly in first gear to get the quad moving at a moderate pace. When you feel the need to shift, or when you get to the "top" of first gear, pull in the clutch lever. Pull up on the shift lever with your left foot to switch to second gear, then slowly release the clutch and apply a small amount of throttle. Put your quad in first gear and keep the clutch in. Give the quad a little bit of gas so that its got a small rev to it and slowly release the clutch just as you had been before. Do your best to maintain that slight rev to the engine and remember that the clutch is neutral. If you feel the engine will stall, pull in the clutch.  · Today I will be driving a manual ATV. Its a Honda ex and I get it if yours is different.

The main one being, that manual quad bikes go through and use gear selection. Switching gears on a manual quad are done via the clutch and shifter, similar to that of driving a manual car. Hence, learning to drive a Polaris ATV without any prior knowledge or experience can be daunting. Today I will be driving a manual ATV. Its a Honda ex and I get it if yours is different. read the manual before taking your first ride or allowing your child to ride your new electric ride-on toy. keep the manual handy for future reference. FOR AGES MONTHS MAXIMUM WEIGHT: 40 lbs. (18 kgs) 6V LITTLE QUAD OWNER'S MANUAL NOTE: Illustrations in this Manual are for reference purposes only and may not reflect the exact.

What parts are needed for a manual ATV. How they work and bonus footage on riding. Pull in the clutch lever and close the throttle slightly. Push the shift lever upwards completely with the tip of your left boot to shift into second gear. Release the clutch lever and open the throttle to accelerate. Repeat to shift into a higher gear as your speed and comfort levels increase. The owner’s manual on your new quad should provide operating tips, riding tips and directions on what you should and shouldn’t do with the ATV, especially before your first ride. Some manufacturers require certain steps be taken before starting the engine for the first time.